20.05.2009, 01:27
Ok if this carb was built for Alcohol then it will never run right with E-85.
It is not possible once it is made for Alcohol to change it back to E-85, everything will be to big now in side the carb.
It will have the wrong needle and seats in it to start with as they are to big .150 or bigger and the needle are made of titanium. This means you can only idle with low fuel pressure, this is why fuel would be coming out of the vent tubes.
Never put rubber hose on the vent tubes or join them togather as it will make problem in side the fuel bowls limiting the amount of fuel the motor gets in the upper rpm.
It would be possible to use this carb with E-98 which is almost pure ethanol, but you will need to get a mechanische Pumpe to make it run right.
Hope this helps Tony
It is not possible once it is made for Alcohol to change it back to E-85, everything will be to big now in side the carb.
It will have the wrong needle and seats in it to start with as they are to big .150 or bigger and the needle are made of titanium. This means you can only idle with low fuel pressure, this is why fuel would be coming out of the vent tubes.
Never put rubber hose on the vent tubes or join them togather as it will make problem in side the fuel bowls limiting the amount of fuel the motor gets in the upper rpm.
It would be possible to use this carb with E-98 which is almost pure ethanol, but you will need to get a mechanische Pumpe to make it run right.
Hope this helps Tony